Optolamp Amazonia Mirim 4 Plus - LED Navigation Light

Optolamp

Price:222.31 ex. VAT

Price: 269.00 (inc. VAT)
24V Power Adapter Available in Parts & Accesories
OPTOLAMP AMAZONIA 4 PLUS SWITCH
14 days
+
Add to wish list
  • Check Shipping Cost
Optolamp Amazonia Mirim 4 Plus Compact 5 in1 LED Navigation Light

  • Tri-colour navigation light
  • Anchor light
  • Fast Strobe light or Slow Strobe light (chosen during installation)
  • Bi-Dimensional vertical beam for emergency situations with a range of 4.3 NM.

Now in its fourth generation, the new Amazonia Mirim 4 Plus features updated electronics, a Delrin housing and base for simplified installation and an extension to the VLE System for use with mast top wind indicators.

TDPS True Dual Power Supply - two power systems in one: a system for the anchor light and another one for the independent tri-colour light give the redundancy required for peace of mind. The electronic controller circuit is sealed for life by encapsulation in resin providing moisture, shock and vibration proofing for the life of the unit.

VLE Vertical Light Emitting - Vertical light emission up to 4.0NM assists aerial rescue services in case of an emergency. The Amazonia Mirim 4 Plus also uses the VLE system in Nav mode with a lower light intensity, designed specifically to illuminate a mast top wind indicator.

16 time less power than a conventional light - maximum light intensity is achieved even with discharged batteries. Maximum stable light intensity within a voltage range from 10.6V to 14,4V and a reduced output as low as 9.5V. It can work approximately 44 nights with a 12V/75A battery. The latest generation of electronic circuit protects against tension peaks in the boat’s electrical system as well as reverse polarity.

Automatic on/off function - for the anchor and strobe functions, a photo sensitive cell automatically switches the lamp on and off at dawn, at night and during storms or fog. Please note, the photo sensitive cell can take over a minute to activate. 

Available in two models for simple installation.

SW Model: Ingeniously uses only 2 wires for Tricolor and Anchor Light functions. The included 3 position mini mode selection switch reverses the connections to the lamp providing both functions with a two core wire, a typical pre existing anchor light installation. The SW model allows quick installation without running new cables through the mast. Adding a third wire adds the fast Strobe Light function or slow Strobe Light with the addition of a simple switch (not included). A standard anchor light 2 core wire provides both nav and anchor light functions allowing upgrade to a third wire when convenient.

Classic Model: Uses 4 wires for Tricolor, Anchor, Strobe Light or Fast Strobe Light. Although the Classic model requires running more wires to the masthead it simplifies installation below decks allowing installation with the pre existing standard on-off boat panel switches. Most panels already have anchor light switches and possibly tri color light switches and spare switches can be used for the strobe light functions if required.

Due to the very low power usage, low gauge wire is perfectly suitable.

Multi-Core Thin Walled Cable


See the Multi-Core Thin Walled Cable for 3, 4 and 5 core small diameter cable.



Technical Information:

  • Height: 127 mm
  • Weight: 220 grams
  • Power source: 10,6V to 14,4V (12v Version)
  • Consumption: (12V) UBC® Ultra Low Consumption - Anchor Light: 0,126A to 0,156A - NAV Light: 0,156A
  • Light source: Electronic emission
  • LED-Lamp Life: 50000 Hs
  • Lens: Polycarbonate, UV protection
  • Horizontal Range: 2,0
  • Vertical Range: up to 4,3 NM
  • Maximum Light intensity: between 10,6V and 14,4V (start at 9,5V)
  • Maintenance free: Led lights don’t have a filament to break or burnt out
  • Fully sealed for life. Shock and Vibration proof. WARRANTY: 2 years

Microswitch included with Switch model

The Switch Model includes a micro switch for mode selection.


Optolamp Amazonia Mirim Base

OPTOLAMP 24V ADAPTER
37.19 ex. VAT   45.00
24 Volt power adapter for the Optolamp Amazonia, Sirius & NAV XXI LED navigation lights. Allows the lights to be connected to 24 volts systems.
In stock
+
Add to wish list

OPTOLAMP SW-310 SWITCH
25.21 ex. VAT   30.50
Surface mount pre-wired 3 way switch allows mode selection and on/off control of the Optolamp Amazonia Mirim 5 in 1 LED Navigation light. The Optolamp...
In stock
+
Add to wish list

OPTOLAMP SW-210 SWITCH
25.21 ex. VAT   30.50
Panel mount waterproof pre-wired 3 way switch allows mode selection and on/off control of the Optolamp Sirius LX LED Anchor light. The Optolamp SW-210 is...
In stock
+
Add to wish list

TW MULTI CORE CABLE 3X1MM
1.09 ex. VAT   1.32
Multi core low gauge electrical cable for use with low voltage/amperage installations such as electronics, LED lights etc. Features a thin outer wall...
Sold by the metre
In stock
+
Add to wish list

Optolamp Mirim 4 Plus Installation (Optolamp_Mirim_4_Plus_Installation.pdf, 51 Kb) [Download]

No posts found

Write a review

Free Shipping
Promotion
Free shipping to some destinations

Orders over €300
to the following
destinations

Austria
Belgium
France
Germany
Italy
Netherlands
Portugal
United Kingdom


Other destinations
from €11.50

Optolamp Sirius LX Plus LED Anchor Light 123.14 ex. VAT  
149.00
Optolamp NAV XXI LED Navigation Light 114.88 ex. VAT  
139.00
Thin Walled Multi-Core Cable 1.09 ex. VAT  
1.32
Ecoflex 10 Ultra Low Loss VHF Cable 2.89 ex. VAT  
3.50
PL 259 Connector for Ecoflex-10 5.37 ex. VAT  
6.50